Thermador PALPKITHC Instrucciones página 7

• Disconnect the female terminal on the spark wire from
the male terminal on the electrode for each burner.
Important:
The locking tab on the female connector must be
depressed to release from the terminal on the electrode.
• Using a 4mm hex wrench, remove the screw attaching
each of the burner pedestals.
• With the burner assemblies removed, the main top is
ready to be lifted off of the appliance.
• An Allen Wrench or similar item can be used as a hook
to lift the main top up, sufficient for removal.
• Remove the shield under the main top, to access the
components underneath.
• The gas regulator is located near the left rear corner,
inside the top area of the appliance.
English 5