How To Use Cleaner Description; On-Off Switch - Hoover C1415 Manual Del Propietário

1-14
N
Pull support toward bottom of han-
dle slightly to make sure support is
locked in place.
Make sure hole in handle (N) is vis-
ible through hole in support.
1-17
Place nut (O) in recessed area at
back of handle. Hold nut in place
while tightening bolt securely with a
screw driver.
Note: Only one nut is needed on this
model. The extra nut is not required
but has been provided for your
convenience.
2. How to use
Cleaner description
2-1
3
4
8
11
12
4
1-15
With cloth bag to the front, place
assembled handle onto handle base
of cleaner body.
Rock handle side to side while push-
ing down firmly. Extra pushing effort
may be required.
1-18
O
Reposition dirt cup into support at
bottom of cloth bag and snap latch-
es into position.
The assembled cleaner will look like the
drawing.
1
1. Handle
2. ON/OFF switch
2
3. Cord hooks: wrap cord around hooks
for storage.
4. Bag cap
5. Cloth bag
5
6. Dirt cup
7. Handle release lever: step on lever
to lower handle to operating or low
position.
8. Cleaner body
6
9. Furniture guard: helps prevent clean-
er from marking furniture.
10. Hood
7
11. Extra belt storage: open door to store
10
extra belt.
12. Carpet height control: slide knob to
9
correct setting for height of carpet
being cleaned.
1-16
Push bolt into hole on lower front of
handle.
If bolt will not go through hole
easily, handle is not pushed com-
pletely down.
1-19
Pull switch lock (P) above ON-OFF
switch (Q) straight out.
Dispose of lock.
Note: If lock has come off during
assembly, make sure switch is in the
OFF position (down) before plugging
cord in to electrical outlet.
Operate cleaner only at voltage specified
on data plate on bottom of cleaner.
WARNING: electrical shock could occur if
used outdoors or on wet surfaces.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a quali-
fied electrician to install the proper outlet.
Do not change the plug in any way.

ON-OFF switch

To turn cleaner ON, push switch up.
To turn cleaner OFF, push switch down.
P
Q