Assembling Cleaner; Carton Contents - Hoover C1415 Manual Del Propietário

1. Assembling cleaner

Carton contents

1-1
B
A
F
Remove all parts from carton and
identify each item shown. Make sure
all parts, especially small items, such
as G and F, are located before dis-
posing of cardboard packaging.
Step 1 Assemble handle
1-2
C
Align upper handle and lower handle as shown.
Place upper (B) and lower (C) handle parts on a flat surface,
aligning rod sections (D). With hands on sides of handle,
push parts together firmly until they "click" and rod sections
lock together.
Step 2 Attach cord
1-3
"UP"
F
E
Insert large rectangular end of cord into pocket in bot-
tom of handle, with side marked "UP" visible.
Make sure rectangular end is pushed into the handle
as far as possible.
Slide cord protector (F) toward upper handle (G).
2
D
C
H
G
A. Upper handle
B. Lower handle
C. Cord
D. Dirt cup assembly
E. Cleaner body
D
It is extremely important to read and
follow all the assembly steps in order.
E
F. Handle bolt and nut pack-
et (One extra nut included)
G. Dirt cup screws (2)
H. Dirt cup support
Note: The white switch lock above the ON/OFF
(A) switch helps in the assembly of your cleaner.
Assembly can be continued if the switch lock is miss-
ing. However, do not remove the switch lock until
assembly is completed.
B
*Do not press against the grey rod extending from the
lower handle shown in Fig. 1-3 (E). Do not push handle
together with hands on ends of sections.
"UP"
G
E
A