Back Panel - Harman Crown ComTech DriveCore CT 475 Manual De Operación

7 Back Panel

1 2 3
1. AC Power Inlet
• Standard IEC type 320 inlet for
detachable connector
• 100-240V
2. Reset Button/Breaker
• Push button switch
• Resets the circuit breaker that protects
the power supply
• A circuit breaker located near the IEC
power inlet protects the amplifier from
excessive AC current draw.
3. Auxiliary Connector
• 3-pin Phoenix type connector
• Allows for amp to be placed in DEEP
SLEEP mode and monitoring of AMP
STATUS (see Section 10.2)
page 10
4 5 6
4. Amp Configuration DIP Switches (see Amp
Status/Configuration in section 10.2)
• Switches 1-5 turn specific settings on and off:
-70 Hz HPF (High Pass Filter
- see Section 8.1)
-Auto-Standby
-Amp Status
-Green Power (See Section 9.2)
-Limiter
• Switches 6-12 sends input channel audio
signal to corresponding output channel and
adjacent output channel. In four channel model,
switch 6-9 are non-functional, (see section 11)
5 6
5. Amp Input Connectors
• 3-pin block connector can be used
per input
• High impedance balanced
6. Channel Level Controls
• One 21-position detented rotary
attenuator per channel
• Attenuation range from -100dB to 0dB
7. Output Speaker Connector
• 4-pin Barrier block type per two channels
(2-Pin or 8-Pin Phoenix can be used)
CT Power Amplifiers
7
Operation Manual