Phono; Line Out Connection - auna 300-BT Manual Del Usuario

PHONO

• Remove the stylus protector. Make sure that the tone arm is being
detached from the tone arm rest before operating and that it is re-
secured again afterwards.
• Select to " Phono " function (6). Then press the BT/Phono button (17) to
"PHONO" position.
• Set the speed selector to the proper position depending on the record
to be played.
• Place the record on the platter (use the spindle adaptor if required).
• Lift the tone arm from the rest and slowly move it to the record side.
The platter will start to rotate.
• Place the tone arm to the desired position of the record.
• Adjust the volume to the desired level.
• At the end of record, the platter will automatically stop rotating. Lift the
tone arm from the record and return it to the rest.
• To stop manually, lift the tone arm from the record and return it to the
rest.
Remarks: As some kind of record the auto-stop area was out of the
unit setting, so it will stop before the last rack finish. In this case, select
the auto-stop switch to " off " position, then it will run to the end of
the record but will not stop automatically (turn off the power button
or switch back the auto-stop switch (34) to " on " position to stop the
platter rotate). Then put back the tone arm to the rest position.

LINE OUT CONNECTION

Connect the system to your hifi system by connecting the line out socket
(32) to the auxiliary input socket with an RCA cable (not included).
EN
31