Encoding Of Cd/Phono Or Cassette Tape To Mp3 Files - auna 300-BT Manual Del Usuario

EN
34
ENCODING OF CD/PHONO OR CASSETTE TAPE
TO MP3 FILES
The system is able to encode audio from CD, record or tape to MP3 format
and recording at memory media to USB drive or SD card.
CD encoding
(1) Recording 1 track
• Play the CD track you want to encode/record, as normal.
• Press the " Record " button (3) during playback of the desired track.
Corresponding symbols will be flashing on the LCD display to show
encoding is in progress.
• After the encoding process has finished, the unit will stop playback
automatically.
(2) Recording the complete CD
• Place a CD with the printed side facing up inside the CD tray & then
close the cd door.
• After disc search has been completed, press the "Record " button (3) –
note: do not press „Play" and then „Record", or only the selected track
will be recorded.
• Corresponding symbols will be flashing on the LCD display to show
encoding is in progress.
• After the encoding process has finished, the unit will stop playback
automatically
(3) Encoding by program
• Place a CD with the printed side facing up inside the tray & then close
the co door
• Select the desire tracks by following " CD disc programming "
procedures. Then press "CD Play/ pause/stop " button (16) to start
playback.
• Duying CD playback, press and hold the " CD Play/pause/stop " button
(16) for 2 seconds to enter the stop mode.
• Press the " Record " button (3) and the unit will display & & flashing.
Encoding is performing now. After completing of encoding, unit will
stop playback automatically.