Mounting The Microphone; Installation Example Using The Original Mounting Bracket - Alpine HALO 9 INE-F904D Manual De Instalación

• If the GPS Antenna is mounted near the unit, the reception becomes
poor, and the location of your vehicle may not be displayed correctly.
- Mount the GPS Antenna far away enough from the unit.
- Bundle the GPS Antenna cable away from the rear of the unit.
• Some thermal reflection type or thermal absorption type glass may
interrupt high frequency waves. If reception is poor with the antenna
installed inside the car, try to mount the antenna outside the car.

Mounting the Microphone

For safe use, make sure of the following:
• Location is stable and firm.
• Does not interfere with safety equipment.
• Driver's view and operations are not obstructed.
• Microphone is located where the driver's voice can be easily
picked up (for example, on the sun visor).
When you speak into the microphone, you should not have to change
your driving posture. This may cause a distraction, taking your
attention away from safely driving your vehicle. Carefully consider
direction and distance while mounting the microphone. Confirm that
the driver's voice can be easily picked up at the selected location.
Microphone
Cable clamp
(Sold separately)
Installation example using the Original
Mounting Bracket
1
Mount the original mounting bracket to the main unit
using the supplied screws.
• If you do not have the original mounting bracket, mount the Double din
KIT* (provided with the side mounting bracket), etc. to the main unit.
* Sold separately.
Original Mounting Bracket
2
Connect all other leads of the main unit according to
details described in the "Connections" (page 9).
Note on using HDMI Connection Cables (HDMI Cable not
included)
When using HDMI connection cables, secure the cables to the HDMI
Terminals with the supplied HDMI Bracket.
1) Slide the HDMI Bracket into the grooves (A).
2) Secure it with the screw (B).
3
Mount the main unit in a car.
• Fix the cables carefully. Do not damage them by mounting them into
movable parts, such as the seat rail, or by locating them against sharp or
pointed edges.
4
Reattach the removed vehicle parts (panels, etc.) or
other aftermarket dash kit back onto the vehicle.
Screws (M5×8)
(Included)
HDMI Terminal
(A)
HDMI Bracket
(Included)
(B)
(A)
5
-EN