Trouble Shooting - Logan Graphic Products 450 Manual De Instrucción Y Operación

I N T E R M E D I A T E +

Trouble Shooting

Problem
Hooks or Curves
Overcut on Top Cut
Overcut on Bottom Cut
Mat Borders Uneven
Ragged Bevel Cut
Not Cutting Through
9
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
Mat Cutter
Solution
Use authentic Logan blades only.
Blade depth set too deep. (see page 6)
Blade is dull.
Blade is catching on previous cut in Slip Sheet. (see page 3)
Uneven pressure being applied to Cutting Head during cut. (see page 5)
Cutting Head crawling forward as you insert the blade. Use Anti-Crawl Pin (see page 5)
Blade depth set too deep. (see page 6)
Adjust where you start and stop in relation to Start and Stop indicator.
Not keeping mat squarely against Squaring Bar when cutting. (see page 4)
Mat Guide not parallel. (see page 7)
Matting material not square.
Cutting without a Slip Sheet (see page 3)
Slip Sheet is worn out. (see page 3)
Not changing the blade often enough.
Machine not on a level surface (see page 8)
Not using a Slip Sheet at least as long as the mat you are cutting. (see page 3)
Slip Sheet not as wide as Guide Rail.
Blade depth set to shallow. (see page 6)
Not keeping same downward pressure
when cutting.
M O D E L 4 5 0