Check Of Contents; Identification Of Machine Components - Logan Graphic Products 450 Manual De Instrucción Y Operación

I N T E R M E D I A T E +
CHECK OF CONTENTS: Model 450 Intermediate+ Matcutter
43 1 / " Cutting Board with Mat Guide, Squaring Bar, Slip Sheet, Straight and Bevel Cutting Heads, Production Stop and (1) five pack of Logan #270
2
Blades.

IDENTIFICATION OF MACHINE COMPONENTS:

Production Stop
Guide Rail
Cutting Board
Start and Stop
Indicator
Anti-Crawl Pin
Bevel Cutting Head
Start and Stop Indicator - Line which shows where to
begin and end cut.
Retaining Screw - Screw which keeps blade safely in
slot when not in use.
Anti-Crawl Pin - Prevents cutting head from creeping
forward during initial penetration of blade into mat.
Nylon Guides - Guides which allow Bevel Cutting Head
to hook onto Guide Rail.
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
Mat Cutter
Squaring Bar
Mat Guide
Retaining Screw
Nylon Guides
Cutting Board
Guide Rail - Used to guide cutting heads
while in use.
Mat Guide - Used to set the border width of
a mat and keep the mat in position.
Squaring Bar - Board mounted 90 degree
bar used to hold mats square when cutting
and as stop when bevel cutting.
Cutting Board - Vinyl covered base board of
machine.
Production Stop - Used to speed up the
process of mat cutting.
Blade Cover
Straight Cutting Head
Blade Holder - Block which holds blade in place while
cutting. Has three separate depth settings.
Blade Cover - Covers blade on Blade Holder.
Blade Screw - Holds blade in place inside Blade Holder.
M O D E L 4 5 0
Blade Screw
Blade Holder
2