Cutting A Beveled Opening Using The Stop - Logan Graphic Products 450 Manual De Instrucción Y Operación

I N T E R M E D I A T E +
6. Attach the 702 Bevel Cutter to the Guide Rail by fitting the black nylon guides over
the raised edge of the channel.
7. Position the cutter so that the Start and Stop Indicator line lines up with the marked
line closest to the top of the machine.
8. Depress the Anti-Crawl Pin and firmly pivot the Blade Holder down into the mat.
Fig. 4
9. Release the Anti-Crawl Pin and pull the cutting head towards you until the Start and
Stop Indicator line lines up with the line on the matboard closest to you. DO NOT
GO PAST THE LINE! Fig. 5
NOTE: It is essential to keep even downward pressure on the Blade Holder as
you cut.
10. Rotate the Blade Holder back up to the neutral position, turn the mat 1/4 turn to the
right and repeat steps 7 through 9 for the remaining three sides.
C. Cutting A Beveled Opening Using the Stop
EXAMPLE: Cutting a mat with a 2" border.
1. Repeat steps 1 through 4 from section B.
2. Insert the production stop into the guide rail as shown and set at the 2" mark.
Fig. 6.
3. Using a pencil, draw one line down the full length of the back of the matboard.
Immediately turn the mat clockwise 1/4 turn.
4. Attach the 702 bevel cutter and position the start and stop indicator over the marked
pencil line. Fig 7.
5. Depress the Anti-Crawl Pin and firmly pivot the Blade Holder down into the mat.
Fig. 7.
6. Release the Anti-Crawl Pin and pull the cutting head towards you until it lightly
makes contact with the production stop. Fig 8.
7. Rotate the blade holder back up to the neutral position, turn the mat 1/4 to the right
and use the cut line in the back of the matboard to start your next cut. Complete this
for the remaining three sides.
5
L o g a n G r a p h i c P r o d u c t s I n c . , 1 1 0 0 B r o w n S t r e e t , Wa u c o n d a , I L 6 0 0 8 4 To l l F r e e 1 8 0 0 3 3 1 6 2 3 2 w w w. l o g a n g r a p h i c . c o m
Mat Cutter
M O D E L 4 5 0
Fig 4
Fig 5
Fig 6
Fig 7
Fig 8