Burner Ignition - GE 31-10251 Manual Del Usuario

Use the screws supplied to attach unit to counter as
shown. The unit must rest on the metal flange around the
burner box and not on the glass.
Fig. 8
HOLD DOWN
BRACKET
CABINET
SIDES
ASSEMBLING THE COOKTOP
BURNERS
The electrode of the spark igniter is exposed
and the mixer tube may have sharp edges. Be
careful not to push any cooktop controls
STOP!
while the top of the burner is removed. Do not
remove the top or touch the electrode of any burner
while another burner is turned on. Electrical shock
might result.
1. Place the burner head on the burner bowl, so that
the location of the spark igniter matches up with the
opening in the burner head.
2. Position the burner cap on the burner head.
3. Place the burner grate over the burner assembly
and into the burner bowl. The bottoms of the burner
grates have fingers that fit into the corresponding
indentations in the burner bowl.
Fig. 9
MIXER TUBE
BURNER
BOWL
MOUNTING
SLOT
BURNER BOX
SIDES
USE SUITABLE
FASTENERS FOR
ANCHORING IN
CABINET SIDES
BURNER GRATE
BURNER CAP
BURNER HEAD
SPARK IGNITER
MIXER TUBE
(CHIMNEY)
CHECK THE IGNITERS
Operation of electric igniters should be checked after
cooktop and supply line connectors have been care-
fully checked for leaks and cooktop has been con-
nected to electric power.
1. Push and turn a burner valve to the LITE position.
A. The burner valve should light when gas is
available to burner.
B. Once the burner lights, it should be turned out
of the LITE position.
2. Try each valve separately until all burners have
been checked.

BURNER IGNITION

COOKTOP SPARK IGNITION —
turn the cooktop knob to LITE , the spark igniter makes
a series of electric sparks (ticking sounds) which light
the burner.
During a power failure the burners will not light
automatically. In an emergency, a cooktop burner may
be lit with a match by following the steps below.
WARNING:
Lighting gas burners with a match is
STOP!
dangerous. You should match light the
cooktop burners only in an emergency.
1. Light a match and hold the flame near the burner
you want to light. Wooden matches work best.
2. Push in and turn the control knob slowly. Be sure
you are turning the correct knob for the burner you
are lighting.
NOTE: If the burner does not light within
five seconds, turn the knob off and wait
one minute before trying again.
5
When you