Maintenance; Trouble Shooting - Nobles Speedshine 1700LS Manual De Operación Y De Piezas

5. To stop machine, rotate twist grips backward and
safety lock button will engage.
FOR SAFETY: When using machine, do not
release handle grips until pad comes to a
complete stop.
NOTE: Machine's circuit breaker will trip under
conditions of excessive overload. Periodically check
pad for excessive soil build–up. Turn pad over, clean
or replace when necessary. If circuit breaker should
trip. Reset circuit breaker switch after 15 seconds by
pushing button at side of handle. Resume to normal
operating.
WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.

TROUBLE SHOOTING

PROBLEM
Machine does not operate.
Machine circuit breaker trips
continuously. continuously
Speedshinet 1700LS/1700HD/1700DS/2000LS/2000HD/2000DS (07–99)

MAINTENANCE

electrocution can result. Unplug machine before
servicing.
1. Remove pad driver or brush after every use. This
2. Clean machine base assembly after every use.
3. Always wash pads after each use. Never use
4. Always wind power cord around cord hooks rather
5. Gear system and motor are factory lubricated and
CAUSE
Machine unplugged.
Machine circuit breaker tripped.
Building circuit breaker tripped.
Faulty power cord.
Faulty wiring.
Faulty twist grip switch.
Capacitor burned out (Single speed
models only).
Rectifier burned out (Dual speed
models only).
Soiled Pad.
Improper pad for application
Defective circuit breaker.
Worn motor brushes.
WARNING: Hazardous Voltage. Shock or
prevents damage to attachments.
soiled pads or allow pads to become oversoiled
before changing.
than loosely looped over handle. Wipe cord with
damp cloth after each use. Also, check power cord
for damage, if worn or damaged, replace
immediately.
require no further attention.
SOLUTION
Plug machine in.
Reset breaker on machine.
Reset breaker and change to differ-
ent circuit.
Contact Service Center.
Contact Service Center.
Contact Service Center.
Contact Service Center.
Contact Service Center.
Replace Pad.
Change to proper pad.
Contact Service Center.
Contact Service Center.
OPERATION
9