Installation Of Battery - RS Pro RSHS800 Serie Manual De Uso

Installation of Battery

The instrument is not installed with battery. To complete the
installation, please operate as the following steps:
1. Remove the two screws on the battery cover using a screwdriver.
As shown in figure 1.
2. Pull out the supporting leg and remove the battery cover. As
shown in figure 2.
3. Place the battery in position and close the cover. As shown in
figure3.
4. Tighten the screws using a screwdriver and turn on the
instrument to check if it's successfully installed.
Notices:
 Connect the battery cable lightly due to its anti-reverse design.
 If the instrument fails to startup after successful installation of
the battery, it is likely due to low battery power,
please charge the battery fully before installation.
 The battery must be charged once every three months.
Figure 1
VI
Figure 3
Figure 2
RSHS800
7