Door Shelves; Adjustable Divider (Some Models); Deepfreeze Features; Frost-Free System - Amana BC20TL Manual Del Usuario

Door Shelves

• Remove door shelves by lifting ends and pulling out.
• Replace door shelves by placing shelf on glides and
sliding down.
Door
shelf
Glide
Adjustable Divider
Adjustable divider keeps items in place and adjusts to
meet individual storage needs. Divider fits in any door
bucket or door shelf.
Adjustable
divider
(some models)
Deepfreeze

Frost-Free System

The Fresh Food and Deepfreeze
completely frost-free. Defrosting is automatic under
normal conditions. Fresh Food and Deepfreeze
never have to be defrosted.
Automatic Ice Maker
• Make sure ice bucket is in place and ice maker arm is
down.
• After freezer section reaches normal temperature, the
ice maker fills with water and begins operating. Allow
24–48 hours after installation before first harvest of ice.
Ice maker produces 7 to 9 harvests of ice in a 24-hour
period under ideal conditions.
• After ice is formed, ice maker drops ice cubes into ice
storage bucket. During ice production, ice maker arm
raises and lowers. When ice storage bucket is full, ice
maker arm turns ice maker off.
Note: Discard first 3 harvests of ice so any impurities left
in the water line after installation are not consumed.
• If you wish to stop automatic ice production lift ice
maker arm. A definite click is heard when proper
position is reached. Ice maker arm will remain in that
position until pushed down.
Ice Service Rack
Install ice service rack by completing the following steps
using a phillips screwdriver:
1. Loosen screw and washer on freezer side wall.
2. Place ice service rack on washers and slide down.
3. Tighten screws and washers.
Move ice service rack by completing the following steps
using a phillips screwdriver:
1. Remove ice service rack by lifting rack off washers,
then pulling out.
2. Remove screws and washers that support ice service
rack. Remove plugs from freezer wall opposite ice
service rack. Replace plugs with screws and
washers. Insert plugs in holes remaining from removal
of screws and washers.
12
™
Features
™
sections are
(some models)
Ice maker
arm
On
position
(some models)
™ sections
Off
position