Working With Your Machine - Viking GE 135 L Manual De Instrucciones

Observe the local regulations regarding
permitted operating times for gardening
power tools with combustion engines or
electric motors.
All worn or damaged parts must be
replaced before use of the machine.
Replace any illegible or damaged danger
signs and warnings on the machine. Your
VIKING specialist has a supply of
replacement stickers and all the other
spare parts.
Before initial operation, it must be ensured
– that the machine is in good operational
condition. This means that the guards
must be in place and in good condition.
– that it is connected electrically to a
properly installed socket.
– that the insulation of the electric cable,
extension cable, plug and connector is
in good condition.
– that the complete machine (motor
housing, guards, fastening elements
etc.) is neither worn nor damaged.
– that there is no shredding material in
the machine and that the feed chute is
empty.
– that all screws, bolts, nuts and other
fastening elements are in place and
properly tightened. Tighten any loose
screws, bolts and nuts prior to initial
operation (observe tightening torques).
Only use the machine out-of-doors and not
close to walls or any other solid objects in
order to prevent the risk of injuries and
property damage (no escape for the user,
broken windows, scratched cars etc.).
The machine must placed in a stable
position on firm and level ground.
0478 201 9811 B - EN
Make sure that you are familiar with the
On / Off switch so that you can react
quickly and correctly in any emergency
situation.
Before using the machine, check that the
shredder box is in proper condition. The
machine must not be used with a damaged
shredder box (risk of injury). A damaged
shredder box must be replaced.
Risk of injury!
Only operate the machine when properly
assembled. If parts of the machine
(e.g. wheels) are missing, the specified
safety distances are no longer maintained
and the stability of the machine may also
be reduced.
Before using the machine, always carry
out a visual check to ensure that it is in
good operating condition.
"Good operating condition" means that the
machine is fully assembled, in particular:
– Wheel carrier assembly is installed
– Both wheels and both feet are mounted
– All safety devices (inserted shredder
box, VIKING cloverleaf opening, etc.)
must be present and functional.
The switch and safety devices installed in
the machine must not be removed or
bypassed.

4.6 Working with your machine

Never work when animals or
persons, particularly children,
are in the danger area.
Do not operate the machine in the rain or
during thunder storms, particularly when
there is a risk of lightning strike.
The risk of accidents is higher if the ground
is damp due to increased danger of
slipping.
Particular caution should be exercised
during working in order to prevent slipping.
If possible, avoid using the machine when
the ground is damp.
Only work during the day or with good
artificial light.
The operator should not stand any higher
than the level of the base of the machine.
Keep the working area neat and tidy at all
times. Remove tripping hazards such as
stones, branches, cables etc.
Starting:
Place the machine in a stable and upright
position prior to starting. The machine
must never be operated in a horizontal
position.
Exercise care when switching on the
machine and observe the instructions in
the section "Operating the machine".
( 10.7)
Do not stand in front of the discharge
opening when starting the engine or
switching on the motor. There must be no
shredding material in the garden shredder
when it is started or switched on.
Shredding material may be ejected and
lead to injuries.
The machine must not be tilted during
start-up.
Avoid switching the machine on repeatedly
within a short period of time; particularly
avoid "playing" with the On / Off switch.
Risk of motor overheating.
Owing to the voltage fluctuations caused
by this machine during the start-up, other
devices connected to the same circuit may
be subject to interference in the case of
11