Somnetics Transcend 3 miniCPAP Guide Rapide página 12

Transcend 3 miniCPAP Quick Guide
Ending therapy
To end the delivery of therapy while the blower is on, press the Power button to
deactivate the blower and return the device to Standby Mode. It is recommended the
user initiate the Drying Mode function after each therapy session to dry the device
interior.
Drying mode
At the end of each therapy session it is recommended the user initiates the Drying Mode.
To initiate Drying Mode depress the Ramp button and press the Power button
simultaneously. When in Drying Mode the blower runs at a low speed for 30 minutes.
During Drying Mode the LED lights remain off and blower pressure is not regulated to
provide therapy. Using the Drying Mode flushes air through the system to remove traces
of moisture from the interior of the device and airway circuit. After the 30-minute drying
cycle, the blower will turn off and the device will automatically enter Standby Mode.
Replacing the Filter Media
The Transcend 3 miniCPAP Filter Media should be replaced every six months at minimum.
Remove the filter assembly by pulling the tab on the back of the device to release it. Then
pull the filter assembly away from the device. Discard the entire filter assembly and
replace with a new one.
Pull tab to release
filter assembly.
Caring for your Transcend 3 miniCPAP and its components
Warnings:
•
Unplug the Transcend 3 miniCPAP before cleaning.
•
Do not submerge the Transcend 3 miniCPAP or power supply in liquid.
•
Prevent water from entering any openings of the device.
•
Do not use harsh or abrasive cleaning agents to clean the device or any
components.
•
Do not attempt to sterilize the Transcend 3 miniCPAP.
•
Do not place cleaning materials, such as a cloth or liquid, into the device air inlet or
air outlet connector.
12
ENGLISH
Page 11