Sony SU-XFQ005 Guia Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Notes on handling the stand
Forcible handling of the stand
may result in serious injury.
Remove the Display Unit and
the connected equipment before
handling the stand, and follow
the notes below.
• Be sure to have at least two people handle the stand.
• Do not grab the glass part.
• Be careful not to pinch your hands or feet.
Do not allow the AC power cord or
the display interface cable to be
pinched.
Do not allow the AC power
cord or the display interface
cable to be pinched when you
attach the Display Unit to the
Floor Stand. If the AC power
cord or the display interface
cable is damaged, this may
result in fire or electric shock.
Do not step on the stand.
You may fall, or break the glass
and cause injury.
Do not stumble over the AC power
cord or the display interface cable.
You may trip, or may cause the
stand to topple over and cause
injury. Bundle the cables
according to the Operating
Instructions to avoid stumbling
on the cables.
Do not disassemble or modify the
stand.
Do not pull out the screw that secures the glass shelf,
or remove the glass. The connected equipment may
drop, or the glass may break and cause injury or
property damage.
CAUTION
If the following precautions are not observed,
injury or property damage may occur.
Do not install any equipment other
than the specified product.
This stand is designed for the use with the specified
product only. If you install equipment other than
specified, it may fall or break, and cause injury.
Be sure to secure the Display Unit.
Secure the Display Unit to the Floor Stand using the
supplied screws. If the Display Unit is not installed
securely, it may fall, or the stand may topple over, and
cause injury.
Do not apply weight to the glass or
subject it to any kind of impact.
Do not apply pressure to the glass when installing the
Display Unit. Do not hit the glass with hard objects,
such as a screwdriver, etc. The glass may break and
cause injury.
Do not subject the glass to excessive
shock.
This stand is made of tempered
glass, but care should be taken.
If the glass breaks, glass
fragments could cause injury, so
observe the precautions below.
• Do not hit the glass or drop
any objects that may break
the glass. Avoid excessive
shock.
• Do not scratch or poke the
glass with sharp-pointed
objects.
• Do not let hard objects such
as a vacuum cleaner hit the
edges of the glass.
Notes on installation
Install the stand on a solid and level floor. Be sure the
stand is placed where it will not be deformed or
inclined. To avoid this, observe the following
precautions.
• Do not install the stand in a place subject to direct
sunlight or near a heater.
• Do not install the stand in a hot or humid place, or
outdoors.
US
3
(US)

Publicidad

Tabla de contenido
loading

Tabla de contenido