Installation - Klarstein 10033000 Manual Del Usuario

INSTALLATION

Note: Do NOT connect the unit to the power supply during installation. The screws
and dowels supplied are only suitable for solid walls. For other walls, e.g. with
cavities, appropriate fixings must be used.
• Unpack the unit, carefully lift the bezel out of the carton and place it upright.
• Find a suitable location for the installation.
• To prevent the heater from slipping from the side brackets during installation, two
additional brackets are supplied.
Note: The heater must not be used until it is securely fastened to the wall.
On the back of the heater there is a bracket on each side as shown. These brackets snap
into the rear wall brackets later and ensure that the unit stands securely. The holders are
not visible later.
EN
21