Klarstein 10033000 Manual Del Usuario página 22

EN
22
1. Hold the heater against the wall to which it is to be attached and mark the height of
the brackets on both sides of the heater. The wall bracket must be mounted approx.
30 mm. inwards.
2. Hold the wall brackets in this position and mark the positions of the screw holes.
3. Drill holes in the wall and insert the dowels.
4. Tighten the wall brackets.
5. The heater is then held against the wall above the position of the brackets and then
lowered so that its mounting brackets snap into place behind the wall brackets as
shown in the picture. This should be done by two people to avoid injury or damage
to property.