Lelit Kate-PL82T Manual Del Usuario página 18

VIP Line - Kate - PL82T
L
Hot water distribution
L.1 Press the hot water (7). The pump starts and the water icon appears on the
display (15), ac-companied by the indication to rotate the steam/hot water knob
(13).
L.2 Place a jug under the steam / hot water wand (17) and open the knob (13)
counter-clockwise until you reach the desired amount.
18
L.3 When the desired amount has been reached, close the knob (13) clockwise
and press the hot water (7) to stop the function.
Note.
function after a pre-determined time. To withdraw more water, repeat the "Dispense hot
water" operation.
for experts
Adjusting the LCC settings
The LCC - Lelit Control Center (15) has pre-set default settings. Here you can
discover how to ad-just them.
M
Changing the factory settings
M.1 Press the "-" button to enter settings mode, and scroll through the menu.
M.2 Press "+" to change the setting. The setting flashes.
M.3 Change its value and/or state by using the "-" and "+" buttons.
M.4 3 seconds after the last press of a button, LCC stores the data and exits
from settings mode.
Note.
about 3 seconds. When the display shows "C-F", release both buttons and afterwards press
the button "+" to convert the temperature from Celsius degrees to Fahrenheit degrees.
About 3 sec onds after the last button has been pressed, the setting will be saved.
The machine is equipped with an electronic control that stops the water
Converting the temperature: press "+" and "-" buttons at the same time for