Built-In Radio Receiver - Dea 124RR Instrucciones De Uso Y Advertencias

Operating instructions and warnings
Instructions
The control board is ready to receive instructions
Scroll down the parameters until you visualize procedure P001
Confirm! The control board is ready for the positioning of the door/gate
Position the door/gate in its standstill position while opening
Confirm! The control board has memorized the door/gate position
Scroll down the parameters until you visualize procedure P003
Confirm! The control board awaits a further confirmation
Confirm by pressing on the OK key for a few seconds! The procedure starts
Now the door/gate starts to close in the slow down phase until it
reaches the stroke end while closing (or the limit switch).
On the display you will read "----". Motor stroke memorization done!
WARNING If during the door opening you have no access to the push buttons of the control
board, you may configure and memorize the stroke by using the buttons of a 4-channel remote
control stored in memory
Instructions
18
By pressing on the
1
happen, you must swap the two motor cables (terminals 12 and 13) Only if you use limit switches, first position the door/gate
where you want it to stop in closing and then adjust the closing cam so that it presses on the limit switch associated to it in that
point. Then position the door/gate in the opening position and adjust the opening cam so that it presses on the limit switch
associated to it in that point.
8.3

Built-in radio receiver

DEA 124RR control board includes a 433,92MHz built-in radio receiver accepting both transmitters with
HCS coding (complete rolling code or just fixed part), and HT12E dip-switch coding.
•The type of coding is selected by programming the working parameter n° 8 "type of coding" (see Table
2 Parameters)
Door/gate positioning
Motors stroke memorization
The control board is ready to receive instructions
Door/gate positioning and Motor stroke memorization
Scroll down the parameters until you visualize procedure
P001
Confirm! The control board is ready for the positioning
of the gate/door
Position gate/door in its standstill position after opening
Confirm! Now the gate/door starts to close at a slow
speed until it reaches the stroke end while closing (or
the limit switch).
On the display you will read "P003". Motor stroke memo-
rization done!
Scroll down the parameters until "----". The control board
awaits further instructions
key the door/gate must open, by pressing on the
Function
1
Function
key the door/gate must close. If this does not
Display
Display
1