Functional Description - Milwaukee 6538-1 Manual Del Operador

Symbology
Properly Recycle
Nickel Cadmium
Batteries
Direct Current
Underwriters
Laboratories, Inc.
No Load Revolutions
per Minute (RPM)

FUNCTIONAL DESCRIPTION

3
2
1
1. Bit
2. Clutch adjusting ring
3. Speed switch selector
(Cat. No. 6545-6,6546-6,6547-1,
and 6547-22)
4. Lock switch
5. Battery pack
6. Battery pack release buttons
7. Forward/reverse switch
4
Specifications
Volts
Cat. No. DC No Load RPM
6538-1 2.4 0 - 190
6539-6 2.4 0 - 190
6540-1 2.4 0 - 190
6545-6 2.4 0 - 400/200
6546-6 2.4 0 - 400/200
6547-1 2.4 0 - 400/200
6547-22 2.4 0 - 400/200
4
7
5
6
CHARGING & USING BATTERY PACKS
WARNING!
Charge only MILWAUKEE 12, 14.4
and 18 Volt Power Plus battery
packs in Power Plus chargers.
Other types of batteries may ex-
plode causing personal injury and
damage.
Charge your battery pack before you use
your tool for the first time and when your
tool no longer performs with the power
and torque needed for the job. Never
completely discharge the battery pack.
Standard charging time will vary accord-
ing to the type of charger you use. The
charging time will also vary depending on
the supply voltage and charge needed. For
example, if your battery pack does not
require a full charge, charging time will be
less.
FOR SPECIFIC CHARGING INSTRUCTIONS,
PLEASE READ THE CHARGER
OPERATOR'S MANUAL SUPPLIED WITH
YOUR CHARGER.
Battery packs are affected by tempera-
ture. Your battery pack will perform best
and have longest life if it is charged when
the temperature is between 60°-80°F (15°-
27°C). Do not charge in temperatures be-
low 40°F (5°C) or above 105°F (40°C).
Under these conditions, capacity will be
reduced. (See "Maintenance").
Removing Battery Pack from Tool (Fig. 1)
Fig. 1
Push in the release buttons (1) and pull the
battery pack away from the tool.
Inserting Battery Pack into Tool (Fig. 2)
The battery pack may feel warm after the
charging cycle. If it is warm, maximize the
output of the battery by allowing it to cool
for a few minutes before inserting it into
the tool.
Fig. 2
To insert the battery pack into the tool, push
in the release buttons (1) and slide it into
the body of the tool.
5
1
1