Shure Microflex MX300 Serie Manual Del Usuario página 5

Re-Routing Cable for Bottom Exit
(MX392 Only)
1. Remove the grille.
2. Disconnect wires from screw terminals.
3. Grasp rubber boot within 1/2" of housing, using
gas pliers. Rotate boot and cable ccw to re-
move connector from threaded "L" bracket.
4. Remove cable from microphone housing.
5. Insert cable through access hole in microphone
base.
6. Insert cable connector through hole and thread
it into "L" bracket.
7. If desired, rubber strain relief can be reattached
to cable end or removed from cable before fas-
tening it to bracket.
8. Re-connect wires to proper screw terminals on
circuit board.
9. Insert supplied round rubber plug into unused
side cable exit.
10. Reinstall grille and foam screen.
11. Insert cable through hole in mounting sur-
face. Secure microphone to mounting surface.
Painting
A supplied plastic paint shield
B retainer
C grille
D foam screen
E supplied adhesive masking strip
F supplied rubber plug
1. Remove foam screen from grille before painting
2. Clean surfaces to be painted with denatured
alcohol or naphtha.
3. To avoid filling grille holes, apply paint in thin
layers.
4. Important: Use fine sandpaper to remove paint
from the bottom edges of the grille. This en-
sures electrical continuity for proper shielding.
A
B
C
D
E
F
5