D-Link DES-1005P Guia De Instalacion página 3

CONNECTING THE DES-1005P TO YOUR NETWORK
A. POWER
Plug the AC power cord into a free outlet or surge protector, then plug the other end of the DC
power jack into the power port of the DES-1005P. The Power LED will illuminate confirming that
the device has powered up successfully.
B. PoE PORTS (PORTS 1 - 4)
PoE Ports 1 to 4 support 802.3at for up to 30W per port for individual usage.
C. 10/100MBPS ETHERNET PORTS (PORTS 1-5)
These ports offer network speeds of either 10 Mbps or 100 Mbps and can operate in half or full-
duplex transfer modes. These ports also support automatic MDI/MDIX crossover, eliminating the
need for crossover cables or uplink ports. Each port can be connected directly to a server, hub,
router, or switch using regular straight-through twisted-pair Ethernet cables.
LED INDICATORS
The LED indicators allow you to monitor, diagnose, and troubleshoot any potential problem within the
switch, connection, or attached devices.
LED
Power
Link/Act/Speed
PoE ( Ports1 to 4 )
PoE Max.
DES-1005P
Color Status
Solid light
Green
Off
Solid light
Green
Blinking
Off Light off
Solid light
Green
Off
Amber Blinking
Solid light
Amber
Blinking
Off Light off
Description
Power on
Power off
Connection to a 10/100 Mbps Ethernet device.
The port is receiving or transmitting data.
No link
The port is successfully connected to a PoE
device and is powering the device properly.
No connection to a PoE device
A valid PoE load is connected to port output
lines, but the switch does not have sufficient
power for supplying the required load power.
Port power is not activated
Total power consumption is above 53W.
Output power to PoE devices has exceeded the
maximum power budget (60W).
Total power consumption is below Power Guard
Band (53W).
3