Placing The Speakers; Connecting The Speakers; Bare Wire Connections - Pioneer VSX-1021-K Guía De Inicio Rápida

▼ ✁ ✂ ✄ ☎ ✂ ✆
❘
▲
❈
❙ ❲
❙ ❘
✝ ✞ ✟ ✄ ☎ ✂ ✆
❙ ▲
❘
▲
❩ ✠ ✡ ☛ ☞
Other speaker connections
Your favorite speaker connections can be
✌
selected even if you have fewer than 5.1
speakers (except front left/right speakers).
When not connecting a subwoofer, connect
✌
speakers with low frequency reproduction
capabilities to the front channel. (The
subwoofer's low frequency component
is played from the front speakers, so the
speakers could be damaged.)
After connecting, be sure to conduct the
✌
Full Auto MCACC (speaker environment
setting) procedure. See Automatically
conducting optimum sound tuning (Full Auto
MCACC) on page 16 .

Placing the speakers

Refer to the chart below for placement of the
speakers you intend to connect.
✎ ✏
❋ ✒ ✍ ❋ ✒ ✔
✑
✍ ✔
✸ ✕ ✸ ✕
❋ ✏ ✍ ❋ ✏ ✔
✻ ✕ ✻ ✕
✶ ✖ ✕ ✶ ✖ ✕
✎ ✍
✎ ✔
✻ ✕
✎ ✓ ✍ ✎ ✓
✎ ✓ ✔
Place the surround speakers at 120º from
✌
the center. If you, (1) use the surround
back speaker, and, (2) don't use the front
height speakers / front wide speakers, we
recommend placing the surround speaker
right beside you.
If you intend to connect only one surround
✌
back speaker, place it directly behind you.
Place the left and right front height speakers
✌
at least one meter directly above the left and
right front speakers.

Connecting the speakers

Each speaker connection on the receiver com-
prises a positive (+) and negative (–) terminal.
Make sure to match these up with the terminals
on the speakers themselves.
CAUTION
These speaker terminals carry HAZARDOUS
✌
LIVE voltage. To prevent the risk of electric
shock when connecting or disconnecting the
speaker cables, disconnect the power cord
before touching any uninsulated parts.
Make sure that all the bare speaker wire is
✌
twisted together and inserted fully into the
speaker terminal. If any of the bare speaker
wire touches the back panel it may cause the
power to cut off as a safety measure.

Bare wire connections

CAUTION
Make sure that all speakers are securely
installed. This not only improves sound quality,
but also reduces the risk of damage or injury
resulting from speakers being knocked over or
falling in the event of external shocks such as
earthquakes.
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed
wire.
3 Tighten terminal.
✗ ✷ ✘
✙ ✚ ✛ ✛
Connecting your equipment
Note
Please refer to the manual that came with
✌
your speakers for details on how to connect
the other end of the speaker cables to your
speakers.
Use an RCA cable to connect the subwoofer.
✌
It is not possible to connect using speaker
cables.
02
7
En