Installing Your Refrigerator; Unpacking Your Refrigerator; Adjusting Your Refrigerator; Proper Air Circulation - Haier HBE18 Manual Del Usuario

English

Installing Your Refrigerator

Unpacking Your Refrigerator

1. Remove all packaging material. This includes the foam base, all
adhesive tape holding, refrigerator accessories inside and outside,
and the plastic stoppers holding the shelves. Slide out and remove
plastic or foam guard used to secure the compressor from shipping
damage due to vibration and shock.
2. Inspect and remove any remains of packing, tape or printed materi-
als before powering on the refrigerator.

Adjusting Your Refrigerator

Leveling Your Refrigerator:
• Your refrigerator has two leveling legs, which are located in the front
comers of your refrigerator. After properly placing your refrigerator in
its final position, you can level your refrigerator.
• Levering legs can be adjusted by turning them clockwise to raise your
refrigerator or by turning them counterclockwise to lower your
refrigerator. The refrigerator door will close easier when the leveling
legs are raised.

Proper Air Circulation

• To assure your refrigerator works at the maximum efficiency it was
designed for, you should install it in a location where there is proper
air circulation, plumbing and electrical connections.
• The following are recommended clearances around the refrigerator:
Sides...............3/4 "(19mm)
Top....................2" (50mm)
Back..................2" (50mm)
5