Fitting The Unit In The Roof Hatch; Routing The Electrical Power Supply Leads - Dometic CoolAir RTX1000 Instrucciones De Instalación

CoolAir RTX1000, RTX2000
7.5

Fitting the unit in the roof hatch

➤ Place the parking cooler centrally and facing forwards in the roof hatch
opening (fig. 8).
I
NOTE
Once the unit is in position on the vehicle roof, the seal should make
contact all the way round. Only then can a reliable seal be achieved.
A
NOTICE!
Do not exceed the specified tightening torque under any circumstances.
That is the only way to ensure that the threaded plugs are not pulled out.
➤ Fix the parking cooler in place as illustrated (fig. 9).
7.6

Routing the electrical power supply leads

!
WARNING!
z The electrical connections may only be made by competent
technical staff with the appropriate specialist knowledge.
z Before carrying out any work on electrically operated components,
make sure that they are disconnected from the power supply.
A
NOTICE!
z The connection to the vehicle's electrical system should be protected
by a 40 A fuse for the power supply and a 2 A fuse for the voltage
monitor.
z The battery must be capable of supplying the required current and
voltage (chapter "Technical data" on page 14).
Connect the unit directly to the main power distribution box.
Ask your vehicle manufacturer for the specifications of the main power
distribution box.
Route the power supply lead as illustrated (fig. 0):
➤ Run the wiring loom to the main power distribution box along a route
where it is protected.
➤ Connect the negative lead (black) for the power supply.
➤ Connect the negative lead (black) for the voltage monitor.
➤ Connect the positive lead (red) for the power supply via a 40 A fuse.
➤ Connect the positive lead (red) for the voltage monitor via a 2 A fuse.
➤ Connect the wiring loom to the unit and fix with a cable tie in a suitable
position (fig. 0 2.).
EN
Installation
11