Cleaning The Motor Block; After Cleaning; Storage - Silvercrest SSMKC 600 A1 Instrucciones De Uso

Cleaning the motor block

1) Clean the surfaces with a damp cloth. If necessary, apply a mild washing-up
liquid to the cloth. Afterwards, wipe off with a cloth moistened only with
water to ensure that no detergent remains on the appliance. Then dry the
surfaces thoroughly.
2) When cleaning, always check that the contact switch in the fitting for the
blender 3 is not blocked by soiling residues. If you cannot dislodge any
blockages with the corner of a piece of paper, make contact with Customer
Services. Do not use any hard objects, these could damage the contact
switch.
3) Remove any possible residues on the underside of the motor block 6 with a
dry cloth or a stiff-bristled brush only. Ensure that nothing can get in through
the ventilation openings of the appliance.

After cleaning

Allow all parts to dry well before reassembling and reusing the liquidiser.

Storage

1) If you do not intend to use the blender for an extended period, clean it
thoroughly (see chapter "Cleaning").
2) Wrap the mains cable around the cable retainer 7 on the base of the motor
block 6 in the direction of the arrow.
3) Store the blender in a cool and dry location.
SSMKC 600 A1
GB │ IE │
15 ■