Fitting The Column; Power Supply - Seca 767 Manual De Instrucciones Y Garantía

3. Before you start...
Unpacking
The scope of supply includes:
• Weighing platform
• Column with display head
• 1 WAF 5 Allen key
• 2 Screws
• Battery holder containing
4 mignon-type AA 1.5 V batteries
• 1 set of operating instructions

Fitting the column

The column with the LCD display can be fitted in two positions, allowing you to determine
in which direction the display is legible - facing either towards or away from the platform.
– Place the column in the recess, facing it
in the desired direction.
– Screw the column to the weighing plat-
form from underneath.
If necessary, lay the scale carefully on
its side to tighten up the screws.
– Connect the plug of the connecting
cable to the rear of the scale.
– Then place the scale upright again.

Power supply

The scale is powered exclusively by batteries.
The LC display has a low power consumption – 120,000 weighing operations can be per-
formed with one set of batteries.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Push the battery compartment closure
towards "Battery" and open the cover.
– Connect the cable to the holder and
batteries.
– Place the holder in the battery compart-
ment.
– Close the cover and then turn the scale
back up the right way.
Note: the scale is prepared for use with a seca mains unit which is available as
an accessory.
Model 767
GB
15