Pureeing - Silvercrest SHMSB 300 A1 Instrucciones De Uso

2) Push the whisks 8 or the kneading hooks 9
into the slots 7 until they click audibly into
place and are secure.
GB
MT
3) Insert the mains plug 4 into a mains power
socket.
4) To start operating the appliance, move the speed
switch 2 to the desired speed setting. You
can select between 5 speed settings and also
use the Turbo button 3 (see section "Speed
levels").
5) Press the tool release button 1 to release the
whisks 8 or the kneading hooks 9.
NOTE
For safety reasons, the whisks 8 and kneading
►
hooks 9 can only be released if the speed
switch 2 is set to position "0".

Pureeing

WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
30
Always insert the kneading
hook 9 or the whisk 8
without the ring into the
intended slot on the appli-
ance (labelled with an icon).
Always insert the kneading
hook 9 or the whisk 8 with
the ring on the shaft into the
intended slot on the appli-
ance (labelled with an icon).
ATTENTION! DAMAGE TO PROPERTY!
Never use the blender 0 for hard foodstuff s
►
such as: coff ee beans, ice cubes, sugar,
cereals, chocolate, raw/hard vegetables etc.
This could result in serious damage to the
appliance.
1) Open the fi xture with the safety cover 5 and
hold the safety cover fi rmly.
NOTE
The blender 0 can only be used if the
►
whisks 8 or the kneading hooks 9 are not
installed.
2) Push the blender 0 into the fi xture 5 and
tighten it by turning in the direction of the
arrow and applying slight pressure.
3) To avoid overfl owing, the container used for
blending should only be fi lled to about 2/3 of
its capacity. Select a suitably large container
or use the supplied measuring jug q.
NOTE
► In order to ensure that the ingredients are
properly mixed, the food that is being pro-
cessed should cover at least the lower part
of the blender 0.
► Do not switch the hand mixer on until the
blender 0 has been inserted into the ingre-
dients to be blended.
4) Move the speed switch 2 to the "Blender"
setting (see chapter "Speed levels") and
press the Turbo button 3. Keep the Turbo
button 3 pressed down during the whole
procedure. The appliance stops as soon as it
is released.
ATTENTION! DAMAGE TO PROPERTY!
Do not operate the blender 0 continuously
►
for longer than 1 minute. After one minute of
use, allow the appliance to cool down fully.
SHMSB 300 A1