Installation; Assembly; Hydraulic Connection - Piusi E300 Instalación Uso Y Mantenimiento

ENGLISH (Translated from Italian)
L

INSTALLATION

L1

ASSEMBLY

ATTENTION
PRELIMINARY
INSPECTION
ATTENTION
POSITIONING
L2

HYDRAULIC CONNECTION

NOTE
ATTENTION
ATTENTION
The MINIMUM recommended characteristics for hoses are as follows:
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
The pump must never be operated before the delivery and suction lines
have been connected.
- Verify that all components are present. Request any missing parts from
the manufacturer.
- Check that the pump has not suffered any damage during transport or
storage
- Carefully clean the suction and delivery inlets and outlets, removing any
dust or other packaging material that may be present
- Check that the electrical data corresponds to those indicated on the data
plate
THE MOTORS ARE NOT OF THE ANTI-EXPLOSIVE-TYPE.
For detailed machine assembly instructions, refer to the exploded view:
For machine assembly and installation, always keep the same position indicat-
ed on the exploded diagram in this manual.
Take care to ensure that the unit is installed in a well-ventilated and illumi-
nated environment.
The pump can be installed in any position (pump axis vertical or horizontal)
Attach the pump using screws of adequate diameter for the attachment holes
provided in the bracket of the pump (see section "OVERALL DIMENSIONS"
for their position and dimension).
Before connecting, make sure that the hoses and the suction tank are free
of dirt and thread residue, which could damage the pump and accessories.
Before connecting the delivery hose, partially fill the pump body with the
liquid that needs to be pumped (do not allow the pump to run dry during the
priming stages).
Do not use conical threaded joints that could damage the threaded pump
openings if excessively tightened.
E300
45
45 /124
/56