Description; Setting The Clock; Prior To First Use; Making Coffee - Krups SAVOY EC311 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KR_CAFETIERE_SAVOY_EC311_NC00134935_NAFTA.qxp_Mise en page 1 04/07/2016 11:35 Page8

2. DESCRIPTION

a
Body of the appliance
Lid
b
Water tank
c
d
Water level indicator
Carafe lid
e
Carafe handle
f
g
Carafe
Warming plate
h

3. SETTING THE CLOCK

■ Place the coffee maker on a hard, flat surface.
■ Plug the power cord into a 120V outlet. Fig. 1.
1- When you plug in the coffee maker for the first time, "1:00 pm" will start flashing on the display. Set the
time by pressing the H button (k) to set the hour and the MIN button (l) to set the minutes. Wait a few
seconds, the time is set once it stops flashing on the screen. Fig. 2.
2- You can change or reset the time whenever you wish by pressing and holding the BREW button (m)
then adjusting the time by pressing H for the hours and MIN for the minutes. Wait a few seconds, the
time is set once it stops flashing on the screen.
NB: Your clock is now set and will continue to show the time, even when your machine is in standby
mode. Fig. 3.
If the machine is unplugged or there is a power failure, the clock will revert back to 1:00 pm. Repeat the
instructions above to reset the clock.

4. PRIOR TO FIRST USE

■ Before using your coffee maker for the first time, run a cycle without coffee to rinse the circuit. Fill the water
tank to the maximum level and start a cycle by pressing the brew button (m).
IMPORTANT : Your machine has been designed to work with cold or water at room temperature only.

5. MAKING COFFEE

■ Open the coffee maker lid (b). Fig. 4.
■ Fill the carafe (g) with cold or water at room temperature, then pour it into the water tank (c) Fig. 5.
The number of cups is shown by the water level indicator (d). Do not exceed 12 cups. Fig. 6.
■ Place the carafe (g) with its lid onto the warming plate (h) making sure that it is properly positioned so as
to activate the coffee pouring mechanism. Fig. 7.
■ We recommend removing the filter holder with the filter before adding the ground coffee. If you accidentally
pour ground coffee into the water tank, do not start the cycle. Clean the tank, otherwise the coffee may
block the water circuit.
■ Add 1 KRUPS spoon (o) of ground coffee per cup. Do not exceed 12 spoons (2 ounces). Fig. 10.
■ Make sure that the filter holder (i) is inserted. Fig. 8. Insert the permanent filter (j) or a #4 paper filter into
the filter holder (i). If using a paper filter, make sure it is fully opened and properly positioned in the filter
holder. Figs. 9a and 9b.
■ Close the lid (b).
■ Press the brew button (m). A light next to the BREW button (m) will come on to show that the coffee
maker has started the brew cycle. The machine will beep once it starts. Fig. 11.
8
i
Filter holder
Permanent filter (avoids paper filters)
j
H button
k
l
MIN button
BREW button
m
AUTO button
n
o
Spoon

Publicidad

Tabla de contenido
loading

Tabla de contenido