Installation; Unpacking Cooktop; Minimum Clearances To Combustible Surfaces; Cooktop Dimensions - Caloric CKS3020 Serie El Manual Del Propietario

Installation

Unpacking Cooktop

• Remove all packing and printed material packed
with cooktop.
• Slide cooktop out of box.
• To avoid damage, do not slide cooktop across
countertop.
• Remove grates, burner grates, burner bowls, and
pressure regulator from box.
WARNING
To avoid property damage or personal injury,
observe the following specifications.
Minimum Clearances to Combustible
Surfaces
• 24 inches minimum width base cabinet is
required.
A
C
A. 30" to bottom of cabinet.
B. 1 3/8" minimum to rear wall.
C. 5 7/8" minimum to left side wall.
D. 5 7/8" minimum to right side wall.
E. 1 5/16" minimum front dimension.
• 3" from top of countertop to drawer or other
obstruction under countertop.
• With pressure regulator, drawer must be short or
rear of drawer must be cut for clearance.
• Minimum of 6 1/4" must separate side flanges of
cooktops installed side by side.
• All dimensions are for cooktop installed with
controls on the right side.
D
E

Cooktop Dimensions

A
A. Depth from top of cooktop to bottom of burner box
2 7/8"
B. Overall Top Width 29 1/2"
C. Overall Top Depth 21 1/2"

Countertop Cutout Dimensions

Prepare countertop opening according to dimensions
shown in diagrams. Area beneath cooktop must be
accessible for gas pressure regulator.
W
A. 2 5/16"
B. 2 1/2"
D. 19 3/16"
B
W. 28 1/2"

Securing Cooktop to Countertop

1. Remove burner grates and caps.
2. Remove burners by removing burner screws with
phillips screwdriver. Unplug burners from burner
wires.
3. Remove maintop from burner box.
4. Locate 4 holes, one in each corner.
5. Drill hole through holes in flange into countertop.
• Use size 5/64" drill bit.
• Do not drill through countertop.
6. Insert screws provided into holes and tighten until
cooktop is secure.
7. Reverse steps 1-3 to replace cooktop.
4
B
D
C
A
B