Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Converting Burners for Use with Natural
Gas
1. Remove control knobs, grates, caps, and burner
bowls.
2. Remove burners by removing burner screw with
phillips screwdriver. Unplug burners from burner
wires.
3. Lift maintop off burner box to expose air shutters.
4. Turn orifice hoods counterclockwise (open)
approximately 1 1/2 to 2 turns.
5. Reassemble cooktop.
6. Adjust burner flame if necessary.
• See " Adjusting SurfaceBurner Flame " section.
Gas Supply Pressure
CAUTION
To avoid property damage, maximum gas
supply pressure must not exceed 14" WCP.
• Appliance and individual shutoff valve must be
disconnected from the gas supply piping system
during any pressure testing of that system at test
pressures in excess of ½ psig (3.5kPa)(14" WCP).
• Appliance must be isolated from gas supply piping
system by closing manual shutoff valve during any
pressure testing of the gas supply piping system at
test pressures equal to or less than ½ psig (3.5kPa)
(14" WCP).
• Gas supply pressure for checking regulator setting
must be at least 1" WCP above manifold pressure
shown on rating label.
• Must use pressure regulator supplied with cooktop.
Gas Connection
Connect gas supply to regulator using hard pipe or a
flexible connector. Pressure regulator supplied with this
appliance has a ½ " NPT female connection.
• A manual shutoff, not supplied with cooktop, must
be installed in an accessible location outside of
cooktop.
• Use joint compound that is resistant to action of
propane gas on all male pipe threads.
• Use supplied pressure regulator only.
• Do not overtighten gas fitting when attaching to
pressure regulator. Overtightening may crack
regulator.
• Support pressure regulator with wrench when
installing gas fitting.
WARNING
To avoid property damage or personal injury,
only use a new flexible connector that is AGA/
CGA design certified.
• Do not use an old connector.
• Do not reuse a connector after moving
appliance.
6
Publicidad
Capítulos
Tabla de contenido
