Assembly; Operation - Klarstein Hot Spot Wave Manual Del Usuario

ASSEMBLY

1. Position the heater carefully upside down.
2. Press the wheels to the hole ,then place screws in center round hole of foot base
and screw in tightly with a screwdriver.
3. Repeat for other leg
4. Turn the heater the right way up.
Note: The heater should only be operated at a minimum distance of 1 metre from any
wall or other object. Position the air flow in order to optimize the heating of the room.

OPERATION

Note: Note: During the initial period of use, odour may be produced by the
materials used in the appliance. This is normal. The odour will diminish after a short
period of time.
Control Panel
Display
Power switch
Temperature
Timer
(+) and (-) button
EN
15