Safety Features; Over-Heat Protection - Klarstein Hot Spot Wave Manual Del Usuario

EN
16
1. Place the heater on a flat, stable surface.
2. Uncoil the power cord and plug it into the wall outlet. Lay the power cable securely
on the ground.
3. Turn on the toggle switch on the side of the unit next to the power cord. The display
lights up briefly.
4. Press the button to switch the appliance ON.The digital display will display the room
temperature and both power will be lit. The [-] and [+] buttons can be used to select
full power or half power. This is indicated by the segments to the screen right corner.
Small segment lit = half power.
Both segments lit = full power.
Setting the Timer
Press the TIMER button. The clock symbol will illuminate. Then use the "+" and "-" buttons
to set the number of hours for which the heater is to run before automatically switching
off.
Note: Unplug the appliance from the mains when not in use. The cable can be
wrapped around the plastic cable tidy on the front panel.
Thermostat Function
To set the thermostat :press the TEMP button, then press the [-] or [+] buttons to change
the target temperature. The thermometer symbol will illuminate,and the digital display
will flash, showing the target temperature. After 5 seconds the display will stop flashing
and return to display the room temperature.

SAFETY FEATURES

Over-Heat Protection

• This heater is protected with an over-heat protection cut-out facility that switches it
off automatically if it over-heats.
• Overheating can be caused by obstruction to the air intakes on the back of the
heater or the grill on the front.
• If this occurs please disconnect the heater from the power socket and allow it to
cool for 30 minutes. Remove any obstruction and turn the heater back on.
• The heater should operate normally. Should the problem persist contact your
nearest service centre.