Worx HYDROSHOT WG620E Manual De Usuario página 15

Pivoting quick
connect adapter /
(WA4039)
Rotary cleaning
/
brush (WA4042)
Adjustable power
scrubber (WA1820 / /
WA1821)
Short lance
/
(WA4013)
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
This tool is intended for cleaning and watering.
ASSEMBLY & OPERATION
ACTION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Checking the battery condition
NOTE: Fig. A3 only applies for the
battery pack with battery indicator light.
Charging the battery pack
More details can be found in charger's
manual
ASSEMBLY
Attaching pressure cleaning lance to the
power nozzle
NOTE: When attaching, align the
two projections on the lance with the
grooves of the power nozzle as shown
in Fig. B.
Attaching the multi-spray nozzle
NOTE: when attaching, rotate the nozzle
left and right to make sure the nozzle
fully seated into position and gently
pulling it to make sure it is locked into
position securely.
Attaching the hose to the power nozzle
NOTE: After the hose is attached, check
the connection by gently pulling upon
the hose. It should not be pulled off.
2 in 1: Portable Power Cleaner/Water Sprayer
/ / /
/ / /
/ / /
/ / /
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4
See Fig. B
See Fig. C
See Fig.
D1, D2
Attaching your own water hose
(optional)
1. Remove the hose adapter
2. Attach the home garden hose with
suitable connectors
NOTE: Besides the hose supplied, you
can also connect the power nozzle to
your own water hose with suitable
connectors.
NOTE: Check whether the filter screen
is missing before retightening the hose
adapter. When retightening the quick
hose adapter, please tighten securely.
Otherwise, it may not draw any water
for proper operation.
OPERATION
WARNING: The supplied
battery is not waterproof. To
avoid risk of battery failure, protect
the battery from water exposure
during use. Store the tool and
battery in a dry place after use.
Start
NOTE: At the first use, you need to
empty the air in hose, place the
power nozzle below waist level
(<1.5m/5ft) and set it at high pressure.
Do not start working until the water
goes up along the hose and
sprays out. This could take up to 30
seconds or more depending on
the fresh water source.
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle pattern
according to your work. Spray
patterns 0 , 15 , 25 and 40
0 0 0
applicable for cleaning, and the spray
pattern with the symbol
suitable for watering.
WARNING: Do not shift the
nozzle pattern when the tool is
powered on.
Cleaning
WARNING: Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or
corrosive. (Including window
cleaning liquids, plant foods, or
fertilizers etc.)
NOTE: For proper maintenance after
using with sea water, the product should
be rinsed by fresh water.
Watering
ATTACHMENT OF
ACCESSORIES
A number of accessories have been supplied with
See Fig.
E1, E2, E3
See Fig. F
are
0
See Fig. G
is best
See Fig.
H, I
See Fig. J
EN
15