Philips Mobilo Plus Serie Manual De Instrucciones página 4

English
• To enable recycling, the plastics of the
product have been coded.
• The cardboard packaging has been made of
recycled material and is entirely suitable for
recycling.
Important
• Before using for the first time, check
if the dustbag is placed correctly.
• Never suck up water (or any other
liquid). Never pick up ashes until
they are cold.
• When picking up fine dust, the pores
of the dustbag may become clogged.
This will obstruct the air passage.
Subsequently, the dustbag needs
replacement, although the bag might
be far from full.
• Never use the vacuum cleaner
without the motor protection filter.
This could damage the motor and
shorten the life of your vacuum
cleaner.
• Only use Philips s-bag™ double-layer
paper dustbags (FC8021) or Philips
Sydney+ double-layer paper dustbags
(type HR6999 Sydney+).
• If the mains cord of this appliance is
damaged, it must only be replaced
by Philips or their service
representative, as special tools
and/or parts are required.
Please note that * in the illustration numbers
means: this illustration applies to special models
only.
How to use
- Connecting the hose: push in and rotate
clockwise (fig. 1, 2).
- To disconnect: rotate anti-clockwise (fig. 3).
- To connect the nozzle, the telescopic tube
and the handgrip: insert the narrowed section
into the wider section while turning it a little
(fig. 4).
To disconnect: pull the narrow section out of
the wider section while turning it a little.
- To adjust the telescopic tube to the
required length: grasp the plastic ring and
pull out the upper tube as far as necessary
(fig. 5). Lock the telescopic tube in position
by releasing the plastic ring. This applies to
specific types only.
• Nozzles:
- Combi nozzle. This nozzle is convertible
for use on either carpets (without brush,
fig. 6) or hard floors (with brush, fig. 7);
- Small nozzle, brush nozzle and crevice
nozzle. These can be found in the special
storage compartment (fig. 8-11);
- Adjusting the suction power: (fig.12-13).
Insufficient suction power?
Please check:
- if the slide on the vacuum cleaner is in the
required position;
- if the control at the hand grip is in "open"
position;
- if the dustbag is full;
- if the nozzle, tube or hose is blocked up.
To remove the obstruction, disconnect the
blocked-up item and connect it (as far as
possible) in adverse position. Then the air
will stream through the item in opposite
direction.
Park
If you wish to interrupt vacuum cleaning, you
can place the tube clip into the rest (fig. 14).
You can slide the clip along the tube to change
the height.
In one movement the tube is parked in a
convenient position (fig. 15).
Storage
- Switch the vacuum cleaner off.
- Remove the mains plug from the wall socket.
- Rewind the mains cord by pressing the
cordwinder pedal (i).
4