Replacing The Dustbag - Philips Mobilo Plus Serie Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
- Hitch the lower tube onto the vacuum
cleaner (fig. 16-17). You can slide the clip
along the tube to change the height.

Replacing the dustbag

Replace the dustbag as soon as the "dustbag full
indicator" becomes red, even when the nozzle is
not placed on a surface (fig. 18).
- Switch the vacuum cleaner off.
- Open the cover (fig. 19).
- Push the dustbag holder backwards (fig. 20).
- Remove the full dustbag by pulling the
cardboard tag (fig. 21).
This automatically closes the dustbag.
- Slide the cardboard front plate of the new
dustbag into the two slots of the dustbag
holder as far as possible (fig. 22).
- Push the dustbag holder forwards ("Click!")
(fig. 23).
Note that it is not possible to close the cover
when no dustbag has been placed.
• Philips s-bag™ paper dustbags are available
under type number FC 8021.
The motor protection filter
Your appliance has been equipped with a greatly
improved, triple permanent motor protection filter.
This filter ensures an optimal protection of the
motor. This filter does not need to be replaced.
This means that you can simply throw away the
replacement filter that is supplied with the
dustbags, since this filter is only required for
older versions of this vacuum cleaner.
All you have to do is shake out the permanent
filter and reinsert it into the vacuum cleaner
every time you put in a new dustbag (fig. 24-26).
- Position the filter in the holder as it was
previously placed and press it firmly.
- Push the holder with the clean filter into its
place so that the filter fits correctly at the
bottom.
Replacing the AFS-Micro filter
models)
The AFS-Micro filter will filter through its
electrostatically charged fibres a large part of the
smallest particles of the exhaust air.
Change the AFS-Micro filter when you place
the first of a new set of dustbags.
- Position the lower edge and sides of the new
filter properly behind the ridges of the holder
(fig. 27).
- When closing the holder, ensure that the
filter fits in completely (fig. 28).
S-Class filter
(not in all models)
Instead of the AFS-Micro filter, some vacuum
cleaners are equipped with a revolutionary S-Class
filter. The S-Class filter is capable of removing from
the outlet air at least 99.97% of all the particles
measuring 0.0003 mm and more.
This includes not only normal domestic dust, but
also harmful microscopic vermin such as glycyphagii
and their excrements.
These are known as causes of bronchial allergies.
• To guarantee optimum air filtering, the S-
Class filter needs replacement at least once a
year.
• For replacement, single S-Class filters are
available from your dealer under type n°.
HR 6992 or service n°. 4822 480 10084.
Replacing the S-Class filter
- Open the filter holder (fig. 29).
- Remove the old filter (fig. 30).
- Place the S-Class filter in the filter holder
(fig. 31).
- Put the S-Class filter holder in the appliance
with the lever pointing upwards (fig. 32-33).
- Close the filter holder and push the lever
down (fig. 34).
5
(not in all

Publicidad

Tabla de contenido
loading

Tabla de contenido