Menu Level 1: Set Temperature - Waeco CoolAir CA850S Instrucciones De Instalación

CA-850S_EBA.book Seite 34 Freitag, 16. April 2010 6:46 18
CoolAir
6.3.2

Menu level 1: Set temperature

The unit always starts with a defined value for the room temperature. This
parameter can be configured between 17 and 30 °C:
➤ Start configuration mode (see Chapter "Starting and ending configu-
ration mode" on page 33).
✓ The first digit of the display (fig. 8 on page 6, item 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the Operating Mode button (fig. 8 on page 6, item 4) to
change the parameters.
➤ Use the + and – buttons (fig. 8 on page 6, item 6 and 7) to select the
target value (in °C) at which the unit should start operation.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Press the Operating Mode button (fig. 8 on page 6, item 4) to con-
firm your entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 1 again and can use the + and – buttons to
switch between menu levels.
34
Installation