Menu Level 1: Set Temperature - Waeco CoolAir CA-800-Universal-2 Instrucciones De Instalación

All manuals and user guides at all-guides.com
CoolAir
➤ Additionally press the operating mode button (see fig. 10 on page 6,
Pos. 4) within these 2-4 seconds.
➤ Let go of the ON/OFF button.
➤ Hold the operating mode button pressed until the LED compressor
flashes.
✓ You are now in configuration mode.
✓ The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
menu level and the second and third show the parameter which can
be set – for example,
If you make no entry on the control panel for 60 seconds, the system quits
configuration mode and switches off.
➤ Press the ON/OFF button to quit configuration mode.

6.3.2 Menu level 1: Set temperature

The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
➤ Start configuration mode (see chapter "Start and end configuration
mode" on page 30).
✓ The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
menu level and the second and third show the parameter which can
be set.
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
change the parameter.
➤ Use the + or - buttons (see fig. 10 on page 6, Pos. 6 and 7) to select
the temperature (in °C) with which the system starts.
✓ The digits in the display flash until the parameter you enter is confir-
med.
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
confirm your entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 1 and can use the + and - buttons to switch
between menu levels.
1.17
for menu level 1 and a set value of 17 °C.
Installation
31