Selecting The Temperature - Waeco CoolAir SP-900 Instrucciones De Uso

BA_SP-900.book Seite 27 Montag, 14. April 2008 9:48 09
CoolAir SP-900
8.2 Switching on the air conditioner
Never close all the blower nozzles (1 2, page 3) of the air condi-
tioner simultaneously. The device would ice up inside.
The first time the air conditioner is used, there may be a slight
smell. This is normal and soon goes away.
➤ With the system switched off, press the ON/OFF button (2 6, page 3).
If you switch off the air conditioner completely, it can only be
switched on again using the control panel. The system can only
be switched on using the remote control if it is in standby mode, in
other words switched off using the remote control. If the system is
not going to be used for a lengthy period, switch it off completely
so that the battery is not wasted supplying standby power.
✓ The fan starts at low speed.
✓ The Power LED (2 1, page 3) lights up.
✓ The digital display (2 9, page 3) shows the selected temperature in °C
and the operating mode (e.g.
20 °C).
The compressor is switched on after a 90-second delay. When
switched on, the fan in the condenser unit starts and is always
driven at a constant speed.
8.3

Selecting the temperature

You can select temperatures between 17 °C and 30 °C.
➤ Press + or - on the control panel (2 4/5, page 3) or on the remote control
(3 3/2, page 4) to set the temperature in 1 °C steps.
✓ The digital display (2 9, page 3) shows the operating mode and the
selected temperature in °C.
If mode I or II fails to achieve the selected temperature, switch to
the next mode up or to automatic mode.
All manuals and user guides at all-guides.com
A20
for automatic mode + temperature
Using the air conditioner
27