LAVAZZA Firmo INOVY & MILK Instrucciones De Empleo página 57

Programming allows you to set the dosing of
each component of the beverage: milk, foam
and coffee. During programming, the display
shows the animation of the selected beverage.
The beverage component which is being pro-
grammed (milk, foam and coffee) is highlighted
in the display animation.
The machine will dispense milk, foam and coffee
in sequence. After reaching the required amount
of the programmed beverage, stop supply by
pressing again the previously used buttono.
PROGRAMMING DELIVERY
If the programmed measure exceeds the maxi-
mum allowed (240 ml) the machine will automati-
cally stop delivery, the delivery button will blink
and the last programmed measure will be saved in
the memory.
If there is a power failure during programming, the
last programmed value remains in the memory.
If during a dose programming, water lack is indi-
cated, the machine stops the supply and the dose
being programmed won't be saved. Once filled
the water tank, repeat the dose programming pro-
cedure.
For a new supply cycle, wait for supply buttons
and multifunction button turning on with steady
white light.
Once supply is over, lift and then lower the capsule
loading lever to unload the exhausted capsule.
EN
57