Inglesina moovy Manual De Instrucciones página 20

20
9 It is necessary to tighten the left
hip part of the belt by pulling
the belt behind the slot in the
left tongue of the buckle, then
to fasten the
by pulling the belt behind the
backrest, then to draw the
belt part (loosened behind the
backrest) to the right shoulder
which
pulling the belt behind the slot in
the right tongue of the buckle,
then to stretch the right hip part
of the belt, and before its entry
into the adjusting device to hold
the belt perpendicular to the
CRS (child restraint system)
side (otherwise it is not possible
to run the belt through the
adjuster), and to pull the belt
out of the CRS.
10 To loosen it, push the adjuster
upwards (D) and pull the belt
from inside the car seat (E).
Release the adjuster to lock the
belt again.
11
In order to adjust the belts to
the child's height, follow these
instructions: lift the cover at
the front of the car seat. Press
the hooking tabs of the cylinder
constraining the belt in the
direction of the arrows on the
opposite side to the adjuster.
12 Push the cylinder downwards,
take it out from the lower part
English
INSTRUCTIONS
left shoulder
has to be fastened by
of the seat body and slip it off
the belt.
13 Run the belt (without the
14 buckle) out through the slots on
the seat back.
15
Put the belt back into the slots
at the right height.
16
Put the cylinder back onto the
belt and fix it to the seat body
again, pressing the hooking tabs
and pulling the belt from inside.
IMPORTANT: Never
sharp or pointed objects to
unhook the cylinder as they
could damage the belt.
17
The length of the belt between
the child's legs (F) is adjusted
by running it through the
adjustment buckle (G) so that
the hip belt (H), connected to
it by the locking buckle (I), is
positioned at the height of the
child's pelvis.
18 The buckle is hooked as shown
in Fig. 9, and is unhooked by
simply pressing the red button.
19
ADJUSTING SEAT
INCLINATION
The car seat can be adjusted to
one of 4 different positions. To
change the inclination, fully raise
the lever on the front and slide
the seat with respect to the base.
This operation is easier when
the child is not in the seat.
use