5- Icons On The Screen; 7- Individual Control Installation; Wall Mounted Installation - Saunier Duval CONTROL INDIVIDUAL SDSC-01 Manual De Usuario

6- CONTROL INDIVIDUAL
6.2.4 TIMER
Press the TIMER ON button and set the desired operation start time with the TIME ADJUST buttons. Press the TIMER ON button and set the desired operation start time with the TIME ADJUST buttons. Press the TIMER ON button and set the desired operation start time with the TIME ADJUST buttons.
Pressing the TIME ADJUST buttons once, the timer goes ten minutes backward or forward.
When keeping the TIME ADJUST buttons pressed, the timer goes thirty minutes backward or forward When keeping the TIME ADJUST buttons pressed, the timer goes thirty minutes backward or forward When keeping the TIME ADJUST buttons pressed, the timer goes thirty minutes backward or forward
alternatively.
Press the TIMER OFF button and proceed the same way to set the desired fi nish time.
Press the SET button to confi rm the setting.
6.2.5 ICONS ON THE SCREEN
The icon indicates that the signal which sets the programming is sent.
The icon indicates that the device is in operation. If this goes off, it indicates that the device is off.
The icon indicates that the device is locked.

7- INDIVIDUAL CONTROL INSTALLATION

7.1 WALL MOUNTED INSTALLATION

The diameter of the Individual Control cable must be suitable for its length.
The cabling tube must similarly be suitable for the cables.
Remove a screw located in the lower section of the Individual Control panel to remove the cover.
The unit is fi xed screwed to the wall.
Cover Cover
Note
Do not apply too much force on the screw, as this may dent the cover or break the liquid crystal screen.
Note
Never cut the cables whilst installing the Individual Protection cover.
Individual Control
Board
Wooden assembly screw
(M4X25)
9