8- Connection Of The Individual Control To The Indoor Unit - Saunier Duval CONTROL INDIVIDUAL SDSC-01 Manual De Usuario

8- CONNECTION OF THE INDIVIDUAL CONTROL TO THE INDOOR UNIT

The Individual Control is connected to the signal receiver of the Indoor Unit.
HAZARD!
- Danger of electrical discharge. Before connecting the
device to the electrical supply line, ensure that the
line is not with tension.
- Danger of electrical discharge. If the connection cable
is damaged, have it replaced by the manufacturer,
maintenance chief or other similarly qualifi ed person.
- Danger of electrical discharge. Ensure that the power
supply line is fi tted with a 2/3 pole main circuit
breaker, depending on the model (single phase/three-
phase), with a minimum distance of 3 mm between
the contacts (Standard EN 60335-2-40).
- Fit the installation with short-circuit protection in
order to prevent electrical discharges. This is a legal
requirement.
HAZARD!
- Use an electrical plug which is properly suited to the
electrical power supply cable.
- Use cables in line with applicable local, national and
international regulations on electrical installations.
- Use offi cially approved electrical connections and power
supply cables.
Note
The Individual Control receives its power supply directly from the Indoor Unit.
SIGNAL RECEIVER
INDIVIDUAL
CONTROL