Ups Communicator Self-Diagnostic Software; Possible Malfunctioning - LEGRAND Daker DK 4.5 kVA Manual Del Instalacion

From the website www.ups.legrand.com it is possible to download free of charge a self-diagnostic
software running on WINDOWS (16 e 32 bit) e Linux platforms.
This software can be used for the following functions:
- Display of all the operation and diagnostic data in case of problems.
- Setup of special functions.
- Automatic shutdown of the local computer (Windows and Linux operating systems).
* Windows is a registered trademark of Microsoft Corporation.
The UPS always operates on batteries:
• There is no line voltage
• Line voltage is out of allowed UPS range
• The power supply cable is not correctly connected to mains socket.
• The input circuit breaker has to be reset
• The mains socket is defective
The UPS signals overloading:
• Additional loads to the ones normally connected have involuntarily been connected on the
output line.
• Check all the loads connected to the output
The UPS doesn't operate in battery mode (it shuts down or immediately signals it is close to the
operating limit):
• The UPS has operated with no mains voltage for a long time and has not been able to recharge
the battery. Recharge it for at least 6 hours by connecting the uninterruptible power supply to
the mains.
• The battery is flat due to not using the UPS for a long period. Recharge it for at least 6 hours by
connecting the uninterruptible power supply to the mains.
• The battery has run down due to being used frequently, to ambient conditions, or to having
exceeded its average service life; it is necessary to change it.
The UPS doesn't deliver power to the output:
• Check that the loads are correctly connected to the output sockets
42
®

6 UPs communicator self-diagnostic software

7 Possible malfunctioning