Entry Panel Conversation Length; Analogue Or Coded Mode - Bpt IT/200 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 83

Entry panel conversation length

Lift the receiver
or
press the hands-free key.
Following this operation, a double tone
should sound, prompting you to commence
programming.
2
Key in 27.
7
Key in conversation length
3
2
1
6
5
(in the range 10 to 99
4
9
8
7
0
seconds), e.g. 20 for 20
seconds.
Once finished, you should hear a triple tone
confirming the setting.
Replace the receiver
or
press the hands-free key.
NOTE. The time can only be varied for
audio entry control systems without conver-
sation privacy (e.g. with A/200R).
PROGRAMMING

Analogue or coded mode

(see instructions attached to the digital entry
panels)
Following this operation, a double tone
should sound, prompting you to commence
programming.
Once finished, you should hear a triple tone
confirming the setting.
(
1
) This programming procedure is only
necessary in the event you wish to reconfi-
gure the interface previously programmed
with digital codes.
30
Lift the receiver
or
press the hands-free key.
2
6
Key in 62.
Press 0 for analogue mode
0
(
1
)
or
1 for coded mode.
1
Replace the receiver
or
press the hands-free key.

Publicidad

Tabla de contenido
loading

Tabla de contenido