Telephone Operations; Placing A Call; Answering A Call; Last Number Redial - Clarity C4210 Guia Del Usuario

TELEPHONE OPERATIONS

Placing a Call

1. Press the TALK button (TALK button will
2. To end the call press the TALK button or place
1. Press the keys of the numbers needed to dial.
2. Press the TALK button. Handset will go off-

Answering a Call

If the handset is out of the cradle, press the
TALK button.
If the handset is in the cradle with Auto-Connect
Mode ON, lift the handset.The handset will be in
receiver mode.
If the handset is in the cradle with AutoConnect
mode OFF, lift the handset.The handset will be in
standby mode. Press TALK button to receive
the call.
Refer to BOOST Clarity Power and Volume Control
for information on adjusting volume controls on
Page 19.

Last Number Redial

The last number dialed (up to 32 digits) is stored in
the redial memory until another number is dialed.
To use this feature:
1. Press the TALK button.
2. When you hear the dial tone, press the
3. The phone will automatically dial for you.
24
illuminate GREEN) and dial the number you
wish to call.
the handset in the base.
Or
The LCD will display PREDIAL and the
keys pressed.
hook and dial the displayed numbers.
RD/P button.
TELEPHONE OPERATIONS

Pause Feature

Programming in a pause will cause the phone to wait
four (4) seconds before dialing additional numbers.
This feature may be used when it is necessary to dial
an access code (9, for example) and wait for a sec-
ond dial tone before you can dial an outside number.
Press the RD/P button at the required point during
the memory storage process to program a pause.

Temporary Tone

If you have rotary (pulse) dial service, you can change
from pulse to touch tone (tone) during a call.
1. Make phone call and wait until it
is connected.
2. Press the * key. Keys pressed after this are
sent as tone signals.
3. The phone will automatically reset to rotary
(pulse) service after the call ends.

Lighted Key Pad

The key pad will light for fifteen (15) seconds after
removing the handset from the base.To reactivate
the feature while in standby, press the TALK or the
MEM button.To activate while the phone is in use,
press any key.

Page/Handset Locator

To send a page signal from the base to the handset,
press the PAGE button located on the base of
the telephone.A series of rings will sound from
the handset.
To locate the handset if it is away from the base,
press and hold the PAGE button for approximately
five (5) seconds. A series of rings will sound. Return
the handset to the base or press any
button to cancel the page.
25