Selecting Hose - Nederman 884 Manual De Instrucciones

1 Mounting instruction (fig. 1)
The reel can be wall-, floor- or ceiling mounted according to the pictures.
Maximum installation height above floor level is 4 m. Select a level surface on
which to mount the reel and use the template to mark the holes. Ensure that
suitable fixing bolts are used and that they are secure. The bolts must stand a
torque force of minimum 7600 N.
When choosing mounting place it should be notified that the lifetime of the
hose can be affected by chemicals and strong
UV- or heat radiation.
Weight, incl. hose: 28 - 30 kg
1.1 A. Hose outlet (fig.2 pos. A)
The hose outlet can be rotated and locked in various positions. Select an angle
to ensure a minimum bending angle for the hose against the outlet rollers.
1.2 B. Connection to the pipework system (fig. 2 pos. B)
The reel must be connected to the pipework system with inlet hose only,
minimum 0,5 m. The hose should go through the ring* which shall be fitted on
the bracket. Check that the hose is not twisted or strained after connection. A
stop valve should be fitted on the pipe system before the hose connection.
1.3 Ratchet mechanism (fig. 3)
The hose reel is delivered with a ratchet mechanism which retains the hose
in the required outdrawn position. The ratchet will disengage if the hose is
drawn out a little further and the hose then recoils to the drum. It should be
noted that the hose should be held by the hand as long as possible during the
recoiling.
1.4

Selecting hose

When selecting hose, see dimension and working pressure on the reels
identification label. Also see Figures.
WARNING! Risk of personal injury.
The reel is equipped with spring under tension. Can cause personal injury.
Read the following instructions for hose fitting carfully.
1.5 Hose fitting (fig.4)
1.
Install the reel in the intended place.
2.
Pull the hose through the outlet of the reel and fasten the end of the
hose onto the swivel. Then lay the hose, fully extended from the reel, on
the floor.
3.
Release the safety catch.
4.
Release the latch mechanism by pulling the hose slightly in the direction
of the arrow. Then let the hose slowly coil up on to the reel drum.
5.
Fit the hose stop.
Hose Reel 884 EN
English
User Manual
11